125001299 - 2710A10 DRIVE SHAFT WITH JOINTS (ONE), L/H OR R/H - R + R

Removing ( Refitting )

  • Remove the two bevels and undo the nut fixing the front wheel hub to the driveshaft.
Use a 36 mm USAG spanner modified as shown in the diagram to loosen the above nut.

  • Undo the bolts (1a) and remove the driveshaft complete with joints (1b).
Refitting ( Removing )

  • Place the driveshaft complete with joints (1a) in its housing and fasten it tightening the bolts (1b) to the recommended torque.
FasteningComponentØ  Value (daNm)
1bBoltFront driveshaftsM8(Differential internal driveshaft/intermediate driveshaft side) 3.5 - 4.3, daNm

  • Tighten the nut (1a) fixing the front wheel hub to the driveshaft to the recommended torque using the angular tightening tool (1b).
FasteningComponentØ  Value (daNm)
1aNutFront hubs with bearingM246.7 - 7.4 + 60° - 64°, daNm
DescriptionCode
1bTorque wrench1.860.942.000

  • Make two bevels on the nut collar as illustrated in the diagram.