125001304 - 2710A32 INTERMEDIATE DRIVE SHAFT BEARING SUPPORT - R + R WITH INTERMEDIATE DRIVE SHAFT REMOVED

Removing ( Refitting )

1. Disconnect the electrical connections from the alternator.
DescriptionConnector
1Alternator See A10 ALTERNATOR
2. Undo the upper alternator fixing bolt.

  • Undo the bolts (1a) and remove the rear alternator bracket (1b).

  • Undo the lower alternator fixing bolt (1a), then move the alternator (1b) aside and secure it appropriately.

  • Undo the bolt fixing the intermediate driveshaft bearing support to the crankcase sump.

  • Undo the bolt (1a) and move the electrical wiring mounting (1b).
  • Undo the remaining bolts (2a) and remove the intermediate driveshaft bearing support (2b).
Refitting ( Removing )

  • Place the intermediate driveshaft bearing support in position and secure it tightening the bolts to the recommended torque.
FasteningComponentØ  Value (daNm)
-BoltFront driveshaft bearing support(Support side)

  • Place the electrical wiring mounting bracket in its housing and secure it using the bolt.
  • Tighten the bolt fixing the intermediate driveshaft bearing support to the crankcase sump.
  • Place the alternator in its housing and fasten it temporarily using the lower bolt.
  • Place the alternator rear bracket in its housing and secure it using the bolts.
  • Tighten the alternator fixing bolts to the recommended torque.
FasteningComponentØ  Value (daNm)
-BoltAlternator assembly