125001311 - 3310A14 FRONT DISC BRAKES - R.R.

Removing ( Refitting ) Position the vehicle on the rampEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with removal    Op. 4450B12 FRONT OR REAR WHEELS (TWO) - R+RProceed with the removal(Right and left sides).    Op. 3330E10 L/H OR R/H HOSE (ONE) TO FRONT BRAKE CALIPERS - R+R1. Remove the spring fixing the brake calipers to the brackets.2. Disconnect the electrical connections for the brake pad wear cables.3. Remove the protective plugs (3a), undo the bolts (3b) and remove the front brake calipers (3c) with the pads.

	Name	Connector
2	Left brake pad wear sensor switch	See K20 LEFT BRAKE PAD WEAR SENSOR SWITCH ( FRONT )

1. Undo the bolts (1a) and remove the front brake caliper brackets (1b). 1. Unscrew the bolt (1a) and remove the front brake discs (1b). Refitting ( Removing ) 1. Place the front brake discs (1a) back in their seatings and secure them tightening the bolt (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Pin	FRONT BRAKE DISC.	M8	(Wheel hub side) 1.0 ÷ 1.4

1. Place the front brake discs (1a) back in their seatings and secure them tightening the bolt (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT BRAKE CALIPER BRACKET	M12	(Front steering knuckle side) 11.1 ÷ 12.3

.

When fitting a new brake caliper, the latter is supplied to Parts with no brake fluid; it is therefore necessary to operate as follows:

slacken the bleed screw;insert the end of a transparent pipe into the bleed screw hole;using an ordinary container with the recommended brake fluid, insert brake fluid into the caliper until air bubbles emerge from the threaded hole where the hose is connected;tighten the bleed screw.1. Place the front brake calipers (1a) complete with pads in their seatings, fix them tightening the bolts (1b) to the specified torque and fit the protective plugs (1c).

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	FRONT BRAKE CALIPER ASSEMBLY	M12	(Bracket side) 11.7

2. Connect the electrical connection for the brake pad wear cable.3. Refit in their seats the clips securing the brake calipers to the mounting brackets. Proceed with the refitting    Op. 3330E10 L/H OR R/H HOSE (ONE) TO FRONT BRAKE CALIPERS - R+R(Right and left sides).Bleed the air from the hydraulic braking system    Op. 3330A14 FRONT OR REAR HYDRAULIC BRAKE SYSTEM - BLEED.Proceed with removal    Op. 4450B12 FRONT OR REAR WHEELS (TWO) - R+RConnect the negative (-) battery terminal