4130B34 SUPPLY PIPE FROM FLUID RESEVIOR TO POWER STEERING PUMP R R - Alfa - GT - eLearn

125001412 - 4130B34 SUPPLY PIPE FROM FLUID RESEVIOR TO POWER STEERING PUMP R R

) Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	See A1B BATTERY ( BATTERY NEGATIVE )

Proceed with removal Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R1. Disconnect the electrical connection from the enablement solenoid of the changeover device actuator.2. Disconnect the vacuum intake pipe from the air flow switching device actuator and release it from the fastening.

	Name	Connector
1	Variable geometry control solenoid	See L15 VARIABLE GEOMETRY CONTROL SOLENOID ( CONNECTORS )

3. Disconnect the linkage from the air flow switching cotrol actuator.4. Undo the bolts (4a) and remove the air flow switching control actuator (4b).

Release the fuel vapour recovery pipe and the coolant return pipe to the engine coolant supply reservoir from the fastenings on the power assisted steering fluid reservoir.Drain the power steering fluid from the reservoir using a suitable syringe.1. Undo the bolts (1a) and move the power assisted steering fluid reservoir (1b) aside.

1. Loosen the band and disconnect the supply pipe from the fluid reservoir to the power assisted steering pump, power assisted steering pump side.

1. Loosen the band, disconnect the supply pipe from the power assisted steering fluid reservoir to the pump, reservoir side, and remove it.

Refitting ( Removing

) Connect the supply pipe from the fluid reservoir to the power assisted steering pump, reservoir side and tighten the band.Connect the supply pipe from the fluid reservoir to the power assisted steering pump, pump side and tighten the band.Refit in its seating the power steering fluid reservoir and secure it with its bolts.Fasten the fuel vapour recovery pipe and the coolant return pipe to the engine coolant supply reservoir to the fastenings on the power assisted steering fluid reservoir.Fit the air flow switching device actuator in its seating and secure it using the bolts.Connect the linkage to the air flow switching control actuator.Connect the air flow switching control actuator vacuum intake pipe and secure it to the fastening.Connect the electrical connection from the enablement solenoid of the changeover device actuator.Proceed with refitting Op. 1016A40 IGNITION COIL COVER ON CYLINDER HEAD- R+R.Connect the negative (-) battery terminalTop up the power assisted circuit with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid	POWER ASSISTED STEERING CIRCUIT	TUTELA GI/A	-

Bleed the power steering system as described belowWith the front wheels raised off the ground, with the engine switched off turn the steering wheel to full lock, left and right, 4-5 times.Check and, if necessary, top up the fluid level in the reservoir.Position the vehicle on the ground and start up the engine.Carry out 4 - 5 complete steering wheel rotation cycles (right and left).Top up the fluid level in the reservoir.