125001622 - 5520B10 STARTER MOTOR - R+R

Removing ( Refitting )

• Position the vehicle on a lift.
• Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 Battery

•     Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD ON BULKHEAD - R+R
•     Op. 1080B40 CATALYTIC PRE-CONVERTER - R R

1. Undo the nuts (1a) and disconnect the electrical connections (1b) from the starter motor.

	Description	Connector
1b	Starter motor	See A020 Starter motor

2. Undo the bolts (2a) and remove the starter motor (2b). Refitting ( Removing )

• Place the starter motor in its housing and secure it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value (daNm)
-	Bolt	STARTER MOTOR		(Gearbox side)

• Connect the electrical connections to the starter motor and secure them using the nuts.
•     Op. 1080B40 CATALYTIC PRE-CONVERTER - R R
•     Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD ON BULKHEAD - R+R
• Connect the negative battery terminal (-).
• Remove the vehicle from the lift.