7065A12 FRONT SEAT BELT (ONE), LH OR RH, WITH PRETENSIONER ON WHEEL - R R - Alfa - GT - eLearn

125001985 - 7065A12 FRONT SEAT BELT (ONE), LH OR RH, WITH PRETENSIONER ON WHEEL - R R

Before removing and refitting the pretensioners, the following preliminary operations must be carried out: turn the ignition off (''STOP'') and remove the key; disconnect the battery leads and insulate them; wait for 10 minutes before continuing. FOLLOW ALL THE RECOMMENDED SAFETY RULES FOR AIR BAGS (see 5580C - Warnings and precautions).

Removing ( Refitting

) Op. 7040L40 REAR COMPARTMENT SCUFF STRIP - R R Op. 7050A22 REAR SEAT CUSHION - R+R Op. 7050A14 SPLIT REAR SEAT ASSEMBLY - R+R1. Lift up the bolt cover trim.2. Undo the nut.3. Move the seat belt relay.4. Remove the knob.

1. Undo the nut.2. Remove the pin and release the seat belt.3. Disconnect the electrical connection from the pretensioner.

	Name	Connector
3	Driver''s seat belt pre-tensioner	See Q20 DRIVER''S SEAT BELT PRE-TENSIONER

	Name	Connector
3	Front passenger seat belt pretensioner	See Q21 FRONT PASSENGER SEAT BELT PRE-TENSIONER

4. Undo the bolt.5. Remove the seat belt with pretensioner.

Place the pretensioner in the special cabinet, resting it on a free surface.

Refitting ( Removing

) Refit the pretensioner, making sure that seat connects to the corresponding body retainer.

Handle the pretensioner with extreme care. Ensure the battery is disconnected.

Tighten the pretensioner fixing bolt to the recommended torque.

Do not use impact tools for tightening.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT SEAT BELT PRETENSIONER.	M7/16''''	4.0

Connect the electrical connection for the pretensioner.

	Name	Connector
-	Driver''s seat belt pre-tensioner	See Q20 DRIVER''S SEAT BELT PRE-TENSIONER

	Name	Connector
-	Front passenger seat belt pretensioner	See Q21 FRONT PASSENGER SEAT BELT PRE-TENSIONER

Place the seat belt in position and fit the middle fastening pin.Tighten the middle pin fixing nut.Fit the knob.Fit the seat belt mechanism.Tighten the nut fixing the idler to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT SEAT BELT IDLER	M7/16"	40

Fit the trim. Op. 7050A14 SPLIT REAR SEAT ASSEMBLY - R+R Op. 7050A22 REAR SEAT CUSHION - R+R Op. 7040L40 REAR COMPARTMENT SCUFF STRIP - R RCheck the operation of the system using the Examiner or another tester.