125002098 - E1050 CAN CONNECTION LINES - DESCRIPTION

Description

This vehicle is equipped with a CAN (Controller Area Network) system of electrical connections: it involves a software and hardware solution which is designed to manage the resources on the vehicle efficiently allowing:

  • the sharing of information between the various electronic units;
  • the intergration of several electronic units through one network;
  • a high network information exchange speed;
  • advantages in economic terms because there is a considerable reduction in the wiring/connectors inside the vehicle;
  • superior standards in terms of quality and reliability.
The advantage of using a CAN system stems from the fact that communication takes place between numerous control units and consequently the number of signals to be managed is very high.For this reason the signals travel on a CAN type serial Bus where one wire is high level (H) and the other low level (L); these signals on the CAN Bus are differential types, i.e. the value assigned to the bit is represented by the difference between the CAN-H and CAN-L voltage levels.The different electronic units which make up the system, known as network nodes, are connected to the CAN by means of communication interfaces known as transreceivers; these connection interfaces, integrated in the electronic units, constitute the gate for sending/reading the information at the CAN or at the serial lines.The exchange of information at CAN type serial lines is only possible using a transmission protocol which is the collection of rules that allow communication between two or more nodes by means of the exchange of information or "data packages".The main element of the network is the Body Computer.The Body Computer node is entrusted with "waking up the network" when the ignition key is turned to the ON position (if there is a problem with the Body Computer this task is entrusted to other nodes 5505 CIRCUITI ELETTRICI DEGLI STRUMENTI/INDICATORI.

The Body Computer also carries out the functions of checking the network which make it possible to provide information on:

  • the network activities status;
  • the functional failure status of the individual electronic units (nodes);
  • a possible CAN fault.
The various electronic units process the various signals coming from the corresponding sensors both for their own management and for other control units to which they are sent via the CAN.

The specific structure adopted for this vehicle consists of two CAN communication networks which connect nodes belonging to two different areas:

  • C-CAN for dynamic vehicle control (high speed): bus CAN-H and CAN-L;
  • B-CAN for the management of standard body functions (low speed): bus CAN-A and CAN-B;
the two CAN communication networks are connected to one another by a gateway for transferring joint information, located in the Body Computer Node.

The following nodes are connected to the Body Computer via the C-CAN:

  • engine management control unit;
  • ABS control unit;
  • steering sensor unit for VDC (if fitted).

The following nodes are connected to the Body Computer via the B-CAN:

  • climate control system control unit;
  • instrument panel;
  • radio or radio phone-navigator
  • control unit in driver''s door
Nodes connected to the bodywork network are diagnosed via the CAN, while the dynamic car control network is diagnosed by a specific K lines E8010 CONNETTORE MULTIPLO DI DIAGNOSI.The system also uses "traditional" complementary serial lines for the various connections; for example in the connection between the Body Computer and the siren/volumetric sensors E7015 ALLARME.Power is distributed via the junction units and/or fuses boxes. These are connected to control elements (relays and static actuators) to ensure maximum electrical protection and minimum complexity.    See E1010 SUPPLY.