125002613 - 1056B87 IGNITION/INJECTION SYSTEM CONTROL UNIT MOUNT - R R

Removing ( Refitting ) Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).
DescriptionConnector
-Battery A1B
1. Disconnect the electrical connections (1a) and (1b) from the injection/ignition control unit.
DescriptionConnector
1aEngine management control unit M10A
DescriptionConnector
1bEngine management control unit M10B
2. Release the electrical wiring from the fastening on the injection/ignition system control unit mounting.
Proceed with the removal    Op. 1048A34 SLEEVE(S) FROM FLOW METER TO AIR SUPPLY CAPACITY CASE - R + R.1. Disconnect the electrical connection from the throttle casing integrated with D.V.L. and release the wiring from the band on the mounting.
DescriptionConnector
1Throttle body actuator N75
2. Undo the bolt (2a) and disconnect the earth lead (2b) from the injection/ignition control unit mounting.
DescriptionConnector
2bEarth on engine C40C
3. Undo the bolts fixing the injection/ignition system control unit mounting.
The above bolts also secure the throttle casing integrated with D.V.L. to the modular intake manifold.
1. Remove the injection/ignition system control unit mounting (1a) complete with control unit (1b).
1. At the bench, undo the nuts (1a) and separate the injection/ignition system control unit mounting (1b) from the control unit (1c).
Refitting ( Removing ) 1. At the bench, assemble the control unit (1a) on the injection/ignition system control unit mounting (1b) and fasten it tightening the nuts (1c) to the recommended torque.
FasteningComponentØ  Value(daNm)
1cNutINJECTION/IGNITION SYSTEM E.C.U.M6(Mount side) 0.8 - 1.1
1. Refit the injection/ignition system control unit mounting (1) complete with control unit (1b) back in its housing and secure it tightening the bolts (1c) to the recommended torque.
The above bolts also secure the throttle casing integrated with D.V.L. to the modular intake manifold.
FasteningComponentØ  Value(daNm)
1cBoltBUTTERFLY VALVE CASE/S (MPI)M6(Air chamber side) 0.8 - 1.1
Connect the earth lead to the injection/ignition control unit mounting and secure it using the bolt.Connect the electrical connection to the throttle casing integrated with D.V.L. and fasten the wiring to the band on the mounting.Proceed with the refitting    Op. 1048A34 SLEEVE(S) FROM FLOW METER TO AIR SUPPLY CAPACITY CASE - R + R.Connect the electrical connections to the injection/ignition control unit and fasten the electrical wiring to the injection/ignition system control unit mounting.Connect the negative battery terminal (-).