2398787 - J01 WINDSCREEN/REARSCREEN WASHERS NOT WORKING

With the igntion key in the ON position, when the lever on the right of the steering wheel is operated, the windscreen wash/wipe does not work properly.

If the vehicle is equipped with a rain sensor, the intermittent position corresponds to the AUTO position, in other words, depending on the sensitivity setting for the ring nut, the windscreen wipers are activated automatically if rain is detected.

		Results of the tests
0	PRELIMINARY CHECKS	All OK	Problems met	Operation
	Check that all the windscreen wash/wipe steering column switch unit functions are working	End of diagnosis	Only the windscreen wipers are not working	See table   J02
			The windscreen washer is not working	See table   J03
			Nothing is working	Continue to Step 1
1	STEERING COLUMN SWITCH UNIT RELAY CHECK (POWER CIRCUIT)	All OK	Problems met	Operation
	With the ignition ON, check that the additional current socket in the dashboard is working properly. The socket is located on the tunnel, opposite the centre rear seat. It is possible, for example, to insert the cigar lighter and check that it heats up	Continue to Step 5	The additional current socket in the dashboard is also not working	Continue to Step 2
2	STEERING COLUMN SWITCH UNIT RELAY CHECK (POWER CIRCUIT)	All OK	Problems met	Operation
	Swap the steering column switch unit relay (in the junction unit under the dashboard) with the heated rear windscreen relay (they are next to one another) and check that the windscreen wipers and the rearscreen wiper are working properly after the swap	Continue to Step 3	The two devices are still not working even after the swap	Continue to Step 4
3	REPLACING HEATED REAR WINDSCREEN RELAY (POWER CIRCUIT)	All OK	Problems met	Operation
	Replace the heated rear windscreen relay (which, in reality, was the one for the steering column switch unit) and check that the heated rear windscreen is working properly	End of diagnosis	-
4	STEERING COLUMN SWITCH UNIT RELAY POWER SUPPLY CHECK (POWER CIRCUIT)	All OK	Problems met	Operation
	Restore the two relays to their original positions.With the ignition ON, check that the steering column switch unit relay is correctly supplied by the battery.Also check that the electrical connections between the battery and the relay are not faulty See   E3020  WINDSCREEN WASH/WIPE	Continue to Step 5	No power supply from the battery	Restore the correct power supply to the relay. If necessary, replace the faulty components (if a fuse is involved, search for the cause of the problem first).
			Connections faulty	Restore the correct connections. See   E3020  WINDSCREEN WASH/WIPE
5	CHECKING DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner Plus or Smart) to the Body Computer and check that there are no errors	Continue to Step 6	Faults detected	Continue according to the instructions for the diagnostic equipment
6	CHECK ON STEERING COLUMN SWITCH UNIT	All OK	Problems met	Operation
	Check that the steering column switch unit is correctly supplied both by the battery and by the Body Computer See   E3020  WINDSCREEN WASH/WIPE	Continue to Step 7	Connections faulty	Restore correct connections. If necessary, replace the faulty components (if a fuse is involved, search for the cause of the problem first).
			No power supply from the Body Computer	Replace the Body Computer Op.   5505A32
7	REPLACING STEERING COLUMN SWITCH UNIT	All OK	Problems met	Operation
	Replace the stalk unit Op.   5550A12	End of diagnosis	The fault persists	Search for the fault starting from another symptom'