K68 CONTROL PANEL ESP WARNING LIGHT ON - Fiat - IDEA - eLearn

2398838 - K68 CONTROL PANEL ESP WARNING LIGHT ON

The brakes node sends the ABS warning light on message via the C-CAN network to the body computer which, through the gateway, makes it available via the B-CAN network to the instrument panel node.

If there are faults at the C-CAN, the control unit failure warning lights will light up. The CAN INFORMATION check is designed precisely for this purpose

0	PRELIMINARY CHECKS	All OK	Problems met	Operation
		Results of the tests
	Connect the EXAMINER diagnostic equipment and check the CAN NETWORK INFORMATION: For inactive control units For control units with errors For control units with CAN errors	Continue to Step 1	Presence of faults in the CAN	Continue as instructed by the tester
		Continue to Step 1	Impossible to converse with the Body Computer	Continue to Step 7
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the tester connected and check the BRAKE NODE for: System/component faults CAN faults	Continue to Step 2	System/component faults	Continue as instructed by the tester
		Continue to Step 2	Presence of C-CAN faults	Continue to Step 9
2	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Using the Examiner check, in the Instrument Panel Node ambient, that there are no errors and the following parameters are present.	Continue to Step 3	There are errors	Continue in accordance with the instructions for the diagnostic equipment
3	ELECTRICAL POWER SUPPLY CHECK	All OK	Problems met	Operation
	Check that the Instrument Panel Node electrical power supply is correct.	Continue to Step 4	Positive and/or earth electrical power supply fault.	Replace the defective component (if a fuse is involved, search for the cause of the problem).
4	CHECK ELECTRICAL CONNECTIONS	All OK	Problems met	Operation
	Check the electrical connections between the Body Computer and the Instrument Panel, in particular that each individual pin is correctly connected.	Continue to Step 5	Electrical connections not working.	Restore damaged electrical connection.
5	CHECK WITH ACTIVE DIAGNOSIS	All OK	Problems met	Operation
	With the Examiner in the Instrument Panel Node ambient, check, in active diagnosis, that the ESP warning light is correctly activated	Continue to Step 6	The ESP light does not flash	Replace the instrument panel Op. 5560B11
6	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Using the Examiner, check, in the Body Computer Node ambient, that there are no errors and that the specific parameter varies.	Continue to Step 9	Impossible to connect with the Body Computer control unit.	Continue to Step 7
			There are errors	Continue in accordance with the instructions for the diagnostic equipment.
			The parameter values do not change	Continue to Step 9
7	ELECTRICAL POWER SUPPLY CHECK	All OK	Problems met	Operation
	Check that the Body Computer Node electrical power supply is correct.	Continue to Step 8	Positive and/or earth electrical power supply fault.	Replace the defective component (if a fuse is involved, search for the cause of the problem).
8	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Using the Examiner, check the possibility of connecting with the Body Computer Node.	Continue to Step 6	Impossible to connect with the Body Computer control unit.	Replace the Body Computer Op. 5505A32
9	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace the Body Computer Op. 5505A32