2400312 - 2125C30 gear engagement cable - r r

Removing ( Refitting ) Position the vehicle on the ramp Proceed with removal  - 5530B10  battery - r+r Proceed with removal  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.1. Press the release button (1a) and disconnect the gear selector cable (1b). 2. Disconnect the gear engagement cable.3. Remove the clips (3a) and release the gear selector and engagement cables (3b) from the mounting bracket.
1. Release the gear selector and engagement cables from the fastening on the steering box, then remove them from the engine compartment.
Proceed with removal  - 7040L37  gear lever plate - r r Proceed with removal  - 7040A65  passenger compartment box lock , one , r r Proceed with removal  - 7040A19  cushion padding - r r Proceed with removal  - 7040A28  TRIM on gearbox control panel - R.R. Proceed with removal  - 7040A30  Left instrument panel lower TRIM - R.R.1. Disconnect the gear selector and engagement cables for the manual gearbox.2. Separate the gear selector and engagement cables (2a) from the mounting releasing the clips (2b).3. Remove the gear selector and engagement cables after haivng released the rubber mountings from the support.
Refitting ( Removing ) Place the gear selector and engagement cables in their housings.
Check that the rubber mountings for the gear selector and engagement cables are correctly positioned on the mounting.
Fasten the gear selector and engagement cables to the mounting using the clips.Connect the gear selector and engagement cables to the manual gearbox control lever.Fit the gear selector and engagement cables in the engine compartment and fasten the band to the steering box.Position the gear selector and engagement cables in the housings in the mounting bracket and secure them using the clips.Connect the gear selector and engagement cables.Adjust the gear selector cable following the instructions described below.1. Set the self-adjustment device (quick adjuster) on the gear selector cable, by pulling the part (1a) backwards and lowering the spring guide (1b); release the part (1a) so as to hold the spring guide (1b) in position 2. Manoeuvring the gear selector lever, make sure that the device (2a) slides on the terminal (2b).
1. Position the gear level in neutral and interpose, in the direction shown in the figure, between the reverse inhibition sleeve tooth (1a) and the support barrier (1b), the tool (1c) on the side with a thickness of 11 0.1 mm; then lock the gear lever against the tool so that the dimension does not change.

NameCountry
1cTemplate1.870.786.000
Release the self-adjustment device.Release the gear lever and remove the tool.

NameCountry
-Template1.870.786.000
Engage 5th gear and check that it does not stick.If there is sticking, repeat the adjustment procedure.
Proceed with refitting  - 7040A30  Left instrument panel lower TRIM - R.R. . Proceed with refitting  - 7040A28  TRIM on gearbox control panel - R.R. . Proceed with refitting  - 7040A19  cushion padding - r r . Proceed with refitting  - 7040A65  passenger compartment box lock , one , r r . Proceed with refitting  - 7040L37  gear lever plate - r r . Proceed with refitting  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. . Proceed with refitting  - 5530B10  battery - r+r . Remove the car from the ramps.