2400574 - 5530A10 alternator - r+r

Removing ( Refitting ) Place the vehicle on a lift. - 4450B04  right front wheel r r - 7055B91  Right front WHEEL ARCH LINER - R.R. - 7055B66  Engine compartment DUST SHIELD protection in right front wheel arch - R.R.1. Undo the fixing nuts (1a) and disconnect the exhaust pipe (1b).2. Undo the bolt with nut (2a) for the power unit reaction rod (2b).
1. Slacken the steering tie-rod nut.2. Disconnect steering tie rod (2a) from front hub steering knuckle (2b) using tool (2c).

NameCountry
2cExtractor1.871.000.700
3. Release ABS sensor wiring (3a) from the retainer (3b).4. Undo and remove the bolts with nut fixing the strut to the shock absorber.
1. Remove the right hand drive shaft gaiter boot retaining band.2. Move the power unit (2a) slightly forward and pull drive shaft (2b) to the right, disconnecting it from gearbox joint (2c).
1. Fit a spanner (1a) in the services belt tensioner socket (1b) and rotate it in the direction of the arrow, then release and remove the services belt (1c).
1. Release and remove alternator electrical connections (1a). 2. Undo nuts (2a) and disconnect electrical connections (2b) and (2c) from the alternator.

NameConnector
2bStarter' motor  A20A 

NameConnector
2cStarter' motor  A20B 
3. Undo upper bolt (3a) and lower bolts (3b), then remove alternator (3c).
Refitting ( Removing ) Check that the alternator is not damaged.1. Place the alternator back in its housing and fix it tightening the bolts to the recommended torque.

FasteningComponentØValue(daNm)
1BoltALTERNATOR ASSEMBLYM104.5 ÷ 5.5
2. Connect the electrical connections to the alternator and fix them using the nuts.3. Reclose the electrical connection cover.
Refit the service belt, moving the tensioner by inserting the wrench in the fitting.Reconnect the drive shaft to the joint on the gearbox.Position the drive shaft gaiter and secure with the band.1. Refit the bolts with nut securing the strut to the shock absorber and tighten to the specified torque.

FasteningComponentØValue(daNm)
1BoltFRONT HUB STEERING KNUCKLE.M106.2 ÷ 6.8
2. Do up ABS sensor wiring (2b) to retainer (2a).3. Connect steering tie rod (3a) to front wheel hub strut (3b), then tighten nut (3c) and tighten to the specified torque.

FasteningComponentØValue(daNm)
3cNutSTEERING LINKM103.6 ÷ 4.4
1. Refit the power unit reaction link bolt with nut and tighten.2. Reconnect exhaust pipe (2a) and tighten nuts (2b) to the specified torque.

FasteningComponentØValue(daNm)
2bNutEXHAUST PIPE FLANGEM82.3 ÷ 2.8
 - 7055B66  Engine compartment DUST SHIELD protection in right front wheel arch - R.R. - 7055B91  Right front WHEEL ARCH LINER - R.R. - 4450B04  right front wheel r rRemove the vehicle from the lift.