2400652 - 7005A14 front side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartment

1. If adjustment is carried out after removing the door, tighten the hinge bolts to the specified torque.

FasteningComponentØValue(daNm)
-BoltFRONT SIDE DOOR HINGESM61.5
2. If the hinges had been removed from the door previously, fully tighten the hinge bolts. 3. Undo the bolt (3a) on the check strap (3b) and close the door to push the check strap back in. 4. Loosen the bolts securing the hinges to the bodyshell, using the specific tool.

NameCountry
4Tool for hinges1.878.083.000
5. Adjust the door position, making use of the bolt slots, so that it is perfectly aligned with the body.
It is advisable to work on one hinge at a time. Possible adjustment movements are indicated by arrows.
Fit shims between hinge and door if necessary to ensure the door is adjusted properly, proceeding as follows (the hinge position is adjusted using the door as reference). Remove the door striker.  Refer to op.. 7005B14  front side door catch striker r r1. Loosen the bolts securing the hinges to the bodyshell, using the special tool.

NameCountry
1Tool for hinges1.878.083.000
2. Fit the shims.Screw in the bolts without tightening.Adjust the door position, making use of the movements of the bolt attachment plate, so that it is perfectly aligned with the body. Refit the door striker, see op. 7005B143. After adjustment, tighten the bolts securing the hinges to the bodyshell.

FasteningComponentØValue(daNm)
3BoltFRONT SIDE DOOR HINGESM10 x 1.254.9
Touch up the paintwork in the hinge area.4. Make the door check strap come out and tighten the bolts.

FasteningComponentØValue(daNm)
4BoltREAR DOOR OPENING LIMITERM81.5
Check that the striker and catch fit together properly  Refer to op.. 7005B14  front side door catch striker r r .