2400703 - 7010A08 rear side door interior support frame-r r with door panel removed

Removing ( Refitting ) 1. Open the cover giving access to the glass retainer.2. Provisionally connect the switch unit to the electrical connection (2a) and move the retainer (2b) of the glass (2c) to the access position (as illustrated in the figure). 3. Disconnect the retainer (2b) from the window, then lift the glass (2c) to the end of its travel and secure it in this position with a hook (3a). 4. Disconnect the electrical connection.

NameConnector
4Anti-crush sensor in left rear door  K19 

NameConnector
4Anti-crush safety sensor on right rear door  K24 
1. Lift up the ring nut (1a) and disconnect the electrical connection for the door (1b).

NameConnector
1bRear / rear door coupling left  D35 

NameConnector
1bRear/right door coupling right  D36 
2. Introduce the door electrical connection as far as possible into the door. 3. Undo the perimetral bolts.4. Disengage and push inwards the seal (4a) for the door opening cable pass (4b).
1. Move the frame slightly.2. Disconnect the electrical connection.

NameConnector
2Left rear. door lock geared motor  N55 

NameConnector
2Rear door lock geared motor right  N56 
3. Remove the frame (3a) releasing it from the door opening cable (3b).
If necessary,  - 7205E39  STRIPPING REAR SIDE DOOR INNER SUPPORT FRAME Refitting ( Removing ) Check that the frame is not damaged.1. Before positioning the frame (1a), check that the perimeter seal (1b) is intact and clean. Also check that the support surface of the door frame is clean.
Offer the frame to its seating, securing the door opening cable and connecting the lock motor electrical connection. Position the frame, fit the seal and door electrical connection and tighten the bolts.Connect the door electrical connection and fit the ring nut.Connect the anti-pinch sensor electrical connection.Connect the glass retainer and close the access cover.