2400969 - 7210B75 tail light seat

Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges). Straighten the body if necessary. 1. Use a rotary brush to clean the panel edges in order to expose the spot welds.2. Use a chamfering machine to crop weld spots.3. Drill out the spot welds indicated.4. Use an oxyacetylene torch and steel brush to unweld welds on the roof. Use a chisel and mallet to remove spots drilled previously.5. Remove the tailgate seat. Straighten the panel edges using a hammer and profiled stake.Use a grinding wheel to remove the spot weld residues.Use a rotary brush to clean treated areas.1. Drill out equidistant holes on the car at the points indicated in the figure.2. Apply the electroweldable paint finish. 1. Use a rotary brush to remove the corrosion-proof treatment from around the inner and outer edges of the part. Apply electric weld paint to the edges. Refitting ( Removing ) 1. Position the part correctly on the car and secure using self-locking grippers.2. Fit the tailgate seal and tailgate.Check that it is perfectly aligned and that the surrounding gap is even. Remove the components used for adjustment.1. Use a spot welder to weld the areas shown in the figure.2. Use a MIG welder to fill the holes made previously.3. Use an oxyacetylene torch to hard-solder the roof panel edges. Correct any deformations in the panel using a profiled stake and mallet.1. Use a grinding wheel to level the weldsUse a rotary brush to clean the welded areas. 1. Apply rust-proofing to newly-welded areas.Seal the joint lines between the part and the car.Apply paint.2. Apply wax oil inside the tailgate seat. Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)