2401052 - 5040BC Check activation/deactivation of climate control compressor from linear sensor

Disconnect the electrical connector for the linear sensor.1, Earth 2, Supply 3, Signal Connect a linear potentiometer (full scale deflection 1 Kohm, previously positioned at aruond 500 ohm between the centre pin and one of the side ones) to the pins for the electrical connector of the linear sensor. Place the key in the ON positionUsing a multimeter, check that the voltage between pins 2 (earth) and 3 is about 2.5 V.Start up the engine and switch the air conditioning on, using the special switch located on the climate control unit.The climate control system should work properly under these circumstances.Vary the potentiometer resistance until the reading on the multimeter between pins 1 (earth) and 3 is about 0V.Under these conditions, the air conditioning system goes off provided the engine control Node receives a low pressure signal from the circuit.Vary the potentiometer resistance until the reading on the multimeter between pins 1 (earth) and 3 is about 4.6V.Under these conditions, the air conditioning system goes off provided the engine control Node receives a low pressure signal from the circuit.