2400070 - 1020A20 crank case oil sump - r + r clean seals for sealant application

Removing ( Refitting ) Position the vehicle on the rampEnsure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

Proceed with removal  - 1048A10  air cleaner filtering element - replace Proceed with removal  - 1072C44  exhaust manifold heat shield on bulkhead - r+r Proceed with removal  - 1072C16  exhaust manifold with catalytic converter - r r1. Undo the engine oil drain plug and drain the oil into a suitable container.

Do not disperse the oil into the environment, as indiscriminate dispersal of this product causes pollution.

2. Undo the bolts fixing the manual gearbox and differential to the cylinder block/crankcase.3. Undo the nuts (3a) and the bolts (3b) securing the crankcase sump.4. Use the tool to cut the crankcase sump sealant.

	Name	Country
4	Blade	1.870.718.000

5. Remove the crankcase sump. Refitting ( Removing ) Thoroughly clean the contact surfaces of crankcase sump and cylinder block of sealant residues.Apply silicon sealant around the edge of the crankcase sump.1. Refit the crankcase sump2. Tighten nuts (2a) and bolts (2b) securing the engine block to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
2a	Nut	OIL SUMP	M6	0.8 ÷ 1.0

	Fastening	Component	Ø	Value(daNm)
2b	Bolt	OIL SUMP	M6	0.8 - 1.0

3. Tighten the bolts fixing the manual gearbox and differential to the crankcase sump to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
3	Bolt	MANUAL GEARBOX	M10	(Engine crankcase sump side) 3.6 ÷ 4.4

4. Tighten the engine oil drain plug to the specified torque.

	Fastening	Component	Ø	Value(daNm)
4	-	-	-	-

Proceed with refitting  - 1072C16  exhaust manifold with catalytic converter - r r . Proceed with refitting  - 1072C44  exhaust manifold heat shield on bulkhead - r+r . Proceed with refitting  - 1048A10  air cleaner filtering element - replace . Connect the negative (-) battery terminal. Refill the engine oil lubrication system  - 0010T11  engine oil check level and top up . Remove the car from the ramps.