2400349 - 3330B02 pedal assembly - r r

Removing ( Refitting ) Proceed with removal  - 7040L37  gear lever plate - r r Proceed with removal  - 7040A65  passenger compartment box lock , one , r r Proceed with removal  - 7040A19  cushion padding - r r Proceed with removal  - 7040A28  TRIM on gearbox control panel - R.R. Proceed with removal  - 7040A30  Left instrument panel lower TRIM - R.R. Proceed with removal  - 5580C18  air bag module - r+r
Closely observe the safety regulations established for this operation  See assembly 5580C   air bag system .
Proceed with removal  - 4110A11  steering wheel - r+r for replacement or check for versions with air bag Proceed with removal  - 5550A12  complete stalk unit - r+r for versions with air bag Proceed with removal  - 4110D20  steering electrical control device - r r Proceed with removal  - 1060G42  clutch pedal switch - r r Proceed with removal  - 1060G38  brake pedal switch - r r1. Working at the rear of the brake pedal, press the white coloured retaining tabs (1a) which secure the brake servo push rod (1b) to the brake pedal (1c).
1. Remove the black coloured retaining device (1a), then release the brake servo push rod (1b) from the brake pedal (1c) and keep the cover (1d) for the brake servo push rod spherical head seat.
After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.
1. Release the retaining clips (1a) and disengage the clutch master cylinder push rod (1b) from the pedal.
1. Undo the nuts (1a) and remove the pedal assembly (1b).
Refitting ( Removing ) 1. Fit the pedal assembly (1a) back in its housing and tighten the nuts (1b) to the specified torque.

FasteningComponentØValue(daNm)
-NutPEDALSM8(Brake servo/bodyshell side) 1.8 ÷ 2.6
Connect the clutch pedal by replacing in its seat and press the pedal fully down.1. Fit the new retaining device (1a) onto brake pedal (1b) to secure the retaining clips (1c). Position the cover (1d) for the brake servo push rod spherical head.
After each dismantling operation the black coloured retaining device (1a) for the brake servo push rod must always be replaced even if it appears to be intact.
Lift up the brake pedal and position the brake servo push rod by the retaining device.Press the brake pedal to engage the brake servo push rod with the retaining device. Proceed with refitting  - 1060G38  brake pedal switch - r r . Proceed with refitting  - 1060G42  clutch pedal switch - r r . Proceed with refitting  - 4110D20  steering electrical control device - r r . Proceed with refitting  - 5550A12  complete stalk unit - r+r for versions with air bag . Proceed with refitting  - 4110A11  steering wheel - r+r for replacement or check for versions with air bag . Proceed with refitting  - 5580C18  air bag module - r+r . Proceed with refitting  - 7040A30  Left instrument panel lower TRIM - R.R. . Proceed with refitting  - 7040A28  TRIM on gearbox control panel - R.R. . Proceed with refitting  - 7040A19  cushion padding - r r . Proceed with refitting  - 7040A65  passenger compartment box lock , one , r r . Proceed with refitting  - 7040L37  gear lever plate - r r .