2400492 - 5040A50 pipe from compressor to air conditioner condenser - r+r

Follow the safety instructions (See 5040 - Precautions)
Follow the safety instructions (See 5040 - Precautions)
Removing ( Refitting ) Place the vehicle on a lift. Drain the refrigerant (  - 0010T84  coolant for air conditioning system dehydrate and recharge ).  - 7055A43  central front grille - r r - 4450B02  left front wheel r r - 7055B90  Left front WHEEL ARCH LINER - R.R. - 4450B04  right front wheel r r - 7055B91  Right front WHEEL ARCH LINER - R.R. - 7055B66  Engine compartment DUST SHIELD protection in right front wheel arch - R.R. - 7210E10  R.R. FRONT BUMPER1. Undo the bolt (1a) and disconnect the connector (1b) for the pipe from the compressor to the condenser.
Seal the disconnected connectors, using suitable plugs, to prevent humidity and impurities from entering the system.
1. Undo the bolt (1a) releasing the bracket (1b ).2. Undo the bolt (2a) and disconnect the connector (2b) for the pipe from the compressor to the condenser.
Raise the car.1. Working via the right front wheel arch, undo the bolt (1a) releasing the bracket (1b) supporting the pipe (1c) from the compressor to the condenser. 2. Remove the pipe from the compressor to the condenser (1b) after having released it from the retainer (2a). 3. If necessary, release the pipe (1c) from the bracket (1b).
Refitting ( Removing ) Check that the pipe between the compressor and the condenser is not damaged and that there are no cracks which would affect the seal.
Replace the O-rings for the connectors. Only use green coloured seals, resistant to R134A refrigerant. Lubricate the thread of the connectors using anti-freeze.
If removed, fit the bracket on the pipe.Place the pipe between the compressor and the condenser in position, then fit it on the retainer.Tighten the pipe mounting bracket in position.Lower the vehicle.1. Connect the connector (1a) for the pipe from the compressor to the condenser, compressor side and fasten it by tightening the bolt (1b) to the recommended torque.

FasteningComponentØValue(daNm)
1bBoltCOOLANT SYSTEM FITTINGSM60.9
2. Fasten the bracket (2a) using the bolt (2b).
1. Connect the connector (1a) for the pipe from the compressor to the condenser, condenser side and fasten it tightening the bolt (1b) to the recommended torque.

FasteningComponentØValue(daNm)
1bBoltCOOLANT SYSTEM FITTINGSM60.9
 - 7210E10  R.R. FRONT BUMPER - 7055B66  Engine compartment DUST SHIELD protection in right front wheel arch - R.R. - 7055B91  Right front WHEEL ARCH LINER - R.R. - 4450B04  right front wheel r r - 7055B90  Left front WHEEL ARCH LINER - R.R. - 4450B02  left front wheel r r - 7055A43  central front grille - r r Repressurize using refrigerant (  - 0010T84  coolant for air conditioning system dehydrate and recharge ). Remove the vehicle from the lift.