2400652 - 7005A14 front side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartment

1. If adjustment is carried out after removing the door, tighten the hinge bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT SIDE DOOR HINGES	M6	1.5

2. If the hinges had been removed from the door previously, fully tighten the hinge bolts. 3. Undo the bolt (3a) on the check strap (3b) and close the door to push the check strap back in. 4. Loosen the bolts securing the hinges to the bodyshell, using the specific tool.

	Name	Country
4	Tool for hinges	1.878.083.000

5. Adjust the door position, making use of the bolt slots, so that it is perfectly aligned with the body.

It is advisable to work on one hinge at a time. Possible adjustment movements are indicated by arrows.

Fit shims between hinge and door if necessary to ensure the door is adjusted properly, proceeding as follows (the hinge position is adjusted using the door as reference). Remove the door striker.  Refer to op.. 7005B14  front side door catch striker r r1. Loosen the bolts securing the hinges to the bodyshell, using the special tool.

	Name	Country
1	Tool for hinges	1.878.083.000

2. Fit the shims.Screw in the bolts without tightening.Adjust the door position, making use of the movements of the bolt attachment plate, so that it is perfectly aligned with the body. Refit the door striker, see op. 7005B143. After adjustment, tighten the bolts securing the hinges to the bodyshell.

	Fastening	Component	Ø	Value(daNm)
3	Bolt	FRONT SIDE DOOR HINGES	M10 x 1.25	4.9

Touch up the paintwork in the hinge area.4. Make the door check strap come out and tighten the bolts.

	Fastening	Component	Ø	Value(daNm)
4	Bolt	REAR DOOR OPENING LIMITER	M8	1.5

Check that the striker and catch fit together properly  Refer to op.. 7005B14  front side door catch striker r r .