7010A08 REAR SIDE DOOR INTERIOR SUPPORT FRAME-R R WITH DOOR PANEL REMOVED - Fiat - IDEA - eLearn

2400703 - 7010A08 rear side door interior support frame-r r with door panel removed

) 1. Open the cover giving access to the glass retainer.2. Provisionally connect the switch unit to the electrical connection (2a) and move the retainer (2b) of the glass (2c) to the access position (as illustrated in the figure). 3. Disconnect the retainer (2b) from the window, then lift the glass (2c) to the end of its travel and secure it in this position with a hook (3a). 4. Disconnect the electrical connection.

	Name	Connector
4	Anti-crush sensor in left rear door	K19

	Name	Connector
4	Anti-crush safety sensor on right rear door	K24

1. Lift up the ring nut (1a) and disconnect the electrical connection for the door (1b).

	Name	Connector
1b	Rear / rear door coupling left	D35

	Name	Connector
1b	Rear/right door coupling right	D36

2. Introduce the door electrical connection as far as possible into the door. 3. Undo the perimetral bolts.4. Disengage and push inwards the seal (4a) for the door opening cable pass (4b).

1. Move the frame slightly.2. Disconnect the electrical connection.

	Name	Connector
2	Left rear. door lock geared motor	N55

	Name	Connector
2	Rear door lock geared motor right	N56

3. Remove the frame (3a) releasing it from the door opening cable (3b).

If necessary, - 7205E39 STRIPPING REAR SIDE DOOR INNER SUPPORT FRAME

Refitting ( Removing

) Check that the frame is not damaged.1. Before positioning the frame (1a), check that the perimeter seal (1b) is intact and clean. Also check that the support surface of the door frame is clean.

Offer the frame to its seating, securing the door opening cable and connecting the lock motor electrical connection. Position the frame, fit the seal and door electrical connection and tighten the bolts.Connect the door electrical connection and fit the ring nut.Connect the anti-pinch sensor electrical connection.Connect the glass retainer and close the access cover.