2400906 - 7055A62 moulding on one pillar, l/h or r/h - r+r
Removing
(
Refitting
)
Open the bonnet lid.1. Undo the moulding retaining stud, using the special tool.
Name
Country
1
Scraper blade
1.878.077.000
2. Remove the moulding by withdrawing in the arrowed direction (see
cross section diagram).
1. If necessary, remove the moulding retaining channel (1a) by detaching
the double-sided adhesive strip (1b) from the body.
Refitting
(
Removing
)
Check the moulding and channel
are undamaged.1. Before refitting channel (1a), clean the body area to be bonded
with heptane.2. Position channel (1a) in the seat (as in the cross section diagram),
aligning the lower end (2a) with the body profile (2b). Position
in its seat without removing the protective film (2c) from the adhesive
tape (2d), except for the first edge (2e). 3. With the channel (1a) in place, remove protective film (2e) section
by section and gradually stick channel (1a) to the body. 4. Refit the moulding (4a). Do not proceed as during removal, but
position the moulding over channel (1a) and then fit in place by
doing up the retainer (see cross section).
Removing
(
Refitting
)
Open the bonnet lid.1. Undo the moulding retaining stud, using the special tool.
