2400026 - 0010T12 engine oil and filter replace

.

Engine oil is harmful to the skin: minimize contact of the oil with the skin; in case of contact wash with soap and water.

Position the vehicle on the ramp1. With the engine hot, remove the filler cap.2. Withdraw the oil level dipstick. 1. Undo the drain plug on the engine sump and drain the oil fully into a suitable container.

Be careful when removing the drain plug, as the oil could be very hot.

Do not disperse the oil into the environment, as indiscriminate dispersal of this product causes pollution.

Undo the bolts and remove the engine oil filter top cover.1. Unscrew and remove the cartridge oil filter cover (1a) complete with O-ring (1b).2. Withdraw and remove the cartridge oil filter. Clean the drain plug and screw it on, with its seal, to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	-	ENGINE OIL DRAIN PLUG	-	(Crankcase sump side)

Refit a new cartridge oil filter in its seating.Refit in its seating the cartridge oil filter cover complete with O-ring and tighten.Refill the engine lubrication circuit using the recommended oil.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE LUBRICATION CIRCUIT	SELENIA WR	-

The table shows the quantity for periodic replacement.

Check that the engine oil level on the dipstick is correct.

The oil level should be checked with the vehicle on flat ground.

Refit the filler cap, run the engine at idle speed for about 2 minutes, turn off the engine and wait a few minutes. Check the oil level and that there are no leaks. Remove the car from the ramps.