Remove the running board connector.1. Move the upper section of the floor covering near the passenger
side dashboard aside.2. Disconnect the electrical connection from the inertia switch.
3. Undo retaining nuts (3a) and remove inertia switch (3b)
Refitting
(
Removing
)
Place the inertia switch back in its housing.Connect the electrical connection to the
inertia switch.Tighten the inertia switch fixing nuts.Put the floor trim back in its place.Place the running board connector back
in its housing.Connect the negative (-) battery terminal.
Removing
(
Refitting
)
Ensure that the ignition key is in the
OFF position, then disconnect the negative battery terminal (-). 
