1092A10 CRANKSHAFT SERVICES PULLEY - R.R. - Fiat - IDEA - eLearn

2400186 - 1092A10 Crankshaft services PULLEY - R.R.

) Position the vehicle on the ramp Proceed with removal - 4450B04 right front wheel r r Proceed with removal - 7055B66 Engine compartment DUST SHIELD protection in right front wheel arch - R.R. Proceed with removal - 7055B91 Right front WHEEL ARCH LINER - R.R. Proceed with removal - 1092G10 single engine belt r r1. Fit a pin (8 mm diameter) through the hole on the gearbox, to be used for countertorque.

Check that the pin is correctly inserted in the housing in the engine flywheel.

1. Undo the bolts (1a) and remove the crankshaft pulley (1b).

Refitting ( Removing

) 1. Place the crankshaft pulley (1a) back in its seating and secure it tightening the bolts (1b) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Bolt	CRANKSHAFT PULLEY	M8	(Crankshaft flange side) 2.3 ÷ 2.8

Remove the pin from the hole on the gearbox. Proceed with refitting - 1092G10 single engine belt r r . Proceed with refitting - 7055B91 Right front WHEEL ARCH LINER - R.R. . Proceed with refitting - 7055B66 Engine compartment DUST SHIELD protection in right front wheel arch - R.R. . Proceed with refitting - 4450B04 right front wheel r r . Remove the car from the ramps.