2400198 - 1032A12 CHAIN AND GEARS for timing system - R.R. for timing or Replacement.

Removing ( Refitting ) Position the vehicle on the rampMake sure that the ignition key is in the OFF position. then disconnect the battery negative (-) terminal.

	Name	Connector
-	Battery	A1B

Drain the air conditioner coolant circuit  - 0010T84  coolant for air conditioning system dehydrate and recharge . Proceed with removal  - 4450B04  right front wheel r r Proceed with removal  - 7055B66  Engine compartment DUST SHIELD protection in right front wheel arch - R.R. Proceed with removal  - 7055B91  Right front WHEEL ARCH LINER - R.R. Proceed with removal  - 1092G10  single engine belt r r Proceed with removal  - 1092A10  Crankshaft services PULLEY - R.R. Proceed with removal Proceed with removal  - 2110A60  manual gearbox/engine coupling bracket - r+r Proceed with removal  - 1020A20  crank case oil sump - r + r clean seals for sealant application Proceed with removal  - 1020B10  cover of timing system with chain drive - r + r replace oil seal and gasket1. Undo the bolt securing the driven timing pulley.

Mark the installation position of the exhaust side toothed drive pulley and the toothed drive pulley. If the pulleys are replaced, fit them with the writing turned to the outside.

2. Remove the timing chain (2a) together with the driven timing pulley (2b) and the toothed drive pulley (2c). Using suitable equipment, prepare the moving tensioner and keep it fully retracted using a suitable pin. Refitting ( Removing ) 1. Refit the timing chain (1a) together with the driven timing pulley (1b) and the toothed drive pulley (1c).2. Tighten the bolt securing the toothed driven pulley to the specified torque.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	TIMING DUCT PULLEY	M12	(Exhaust camshaft side) 10.8 ÷ 13.2

Remove the pin from the moving tensioner and check that the moving tensioner piston is in contact with the plate. Proceed with refitting  - 1020B10  cover of timing system with chain drive - r + r replace oil seal and gasket . Proceed with refitting  - 1020A20  crank case oil sump - r + r clean seals for sealant application . Proceed with refitting  - 2110A60  manual gearbox/engine coupling bracket - r+r . Proceed with refitting  - 1092A10  Crankshaft services PULLEY - R.R. . Proceed with refitting  - 1092G10  single engine belt r r . Proceed with refitting  - 7055B91  Right front WHEEL ARCH LINER - R.R. . Proceed with refitting  - 7055B66  Engine compartment DUST SHIELD protection in right front wheel arch - R.R. . Proceed with refitting  - 4450B04  right front wheel r r . Connect the negative (-) battery terminal. Refill the engine oil lubrication system  - 0010T11  engine oil check level and top up . Refill the engine cooling system with coolant  - 0010T20  coolant change . Fill the air conditioner coolant circuit  - 0010T84  coolant for air conditioning system dehydrate and recharge . Proceed with removal . Remove the car from the ramps.