5520B10 STARTER MOTOR - R+R - Fiat - IDEA - eLearn

2400569 - 5520B10 starter motor - r+r

) Position the vehicle on the ramp.Ensure that the ignition key is in the OFF position, then disconnect the negative battery terminal (-).

	Name	Connector
-	Battery	A1B

1. Open the cover (1a), undo the nuts (1b) and disconnect the electrical connections (1c) from the starter motor.

	Name	Connector
1c	Starter' motor	A20

2. Undo the bolts (2a) and remove the starter motor (2b).

Refitting ( Removing

) 1. Place the starter motor (1a) back in its housing and fix it tightening the bolts (1b) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1b	-	STARTER MOTOR	M8	(Engine crankcase side) 2.3 ÷ 2.8

2. Connect the electrical connections (2a) to the starter motor, fix them using the nut (2b) and close protective cover (2c).

Refitting ( Removing

) Check that the starter motor is not damaged.1. Replace the starter motor in its housing and fix it tightening the lower bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STARTER MOTOR	M8	2.4 ÷ 3.0

2. Connect electrical connections (2a) and tighten nuts (2b).

Connect the negative (-) battery terminal.Remove the vehicle from the ramp. 1. Tighten the upper motor bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STARTER MOTOR	M8	2.4 ÷ 3.0

- 5530B10 battery - r+rRemove the vehicle from the lift.