3315740 - E7015 ALARM - Functional description

Functional description

The alarm system is controlled by alarm control unit M30 integral with the siren. The control unit is supplied directly by the battery at pin 3 of connector A from the line protected by fuse F17 and at pin 7 of connector B (supply for the direction indicators) from the line protected by fuse F8 ; both fuses are located in junction unit B1. An ignition-operated power supply (INT/A) reaches pin 12 of connector B of control unit M30 . through a line protected by fuse F5 of control unit B1. Pin 9 of connector A is earthed. Control unit M30 controls door closure via switches N50, N55, N51, N56, which send an earth signal to pins 8, 15, 9 and 16 of connector B respectively when the door is open (the same switches turn on the door open indication leds (  See E2510  COURTESY LIGHTS ). The bonnet lid is controlled by switch I10 , which is connected to pin 18 of connector B, while the boot lid is controlled by switch I11 , which is connected to pin 17 of connector B (the same switch turns on the boot light:  See E2520  GLOVE COMPARTMENT LIGHT - LUGGAGE COMPARTMENT LIGHT - SUN VISOR LIGHT ). Volumetric sensor unit K62 receives supply and earth signals from pins 8 and 11 of connector A of M30 , and sends on the alarm control signal to pin 12 of connector A of M30 . Pin 1 of connector A of M30 sends alarm led control signal E40 . Pins 1 and 2 of connector B of M30 produce control signals for turn signals (  See E2020  DIRECTION INDICATORS / HAZARD WARNING LIGHTS ). Remote control receiver M35 is supplied directly from the battery at pin 3. An ignition-operated power supply (INT/A) reaches pin 7 of M35 via a line protected by fuse F5 of control unit B1 . Pin 4 is earthed. M35 (pins 5 and 6) issue door lock and door release signals (  See E3040  CENTRAL LOCKING ). Control unit M30 and receiver M35 are both equipped with a self-diagnostic system that may be used by connecting to connector R10 , pin 11. This receives signals from pin 6 of connector A of M30 and from pin 2 of remote control receiver M35 . This serial line also acts as a connection between M30 and M35 .