3315341 - 7210E18 R.R. FRONT WING

Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary. 1. Lift the bonnet lid.2. Open the front door.3. Protect the area beneath the windscreen pillar using adhesive tape.4. Remove the PVC treatment between front pillar and wing using a vibrating cutter and appropriate blade.5. Heat and then use an appropriate blade to cut the sealant between front pillar and wing. 1. Unscrew the upper wing retaining bolts.2. Unscrew the wing side retaining bolt.3. Unscrew the lower wing retaining bolts.4. Remove the wing from the car. Refitting ( Removing ) Clean off residues of old sealant, foam and PVC using a vibrating cutter and appropriate blade.1. Position wing ( 1a) to the car and secure provisionally using retaining bolts (1b).Lower the bonnet lid and close the front door. Check the door is aligned and that the gap around the edge is even. Check the wing in accordance with the specified procedure.1. Restore the sealant in the area indicated.2. Reapply plastic foam to the upper wing insert. 1. Position the wing on the car and screw in the retaining bolts without tightening.2. Align the wing and check the edges between wing and door (2a) and bonnet lid (2b).3. Permitted wing adjustment movements are indicated by arrows.4. Fully tighten the wing retaining bolts. 1. Apply sealant to the area indicated (use the specified cycle).2. Reapply PVC treatment to the areas indicated (use the specified cycle).