3315344 - 7210E44 R.R. UNDERDOOR SIDE MEMBER OUTER TRIM/

Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary. 1. Remove the PVC treatment from the door sill to expose the weld spots using a vibrating cutter and appropriate blade.2. Use a rotary brush to clean the panel edges to reveal the weld spots. 1. Use a chamfering machine to crop the weld spots indicated in the figure.2. Use a drill fitted with an appropriate bit to drill out the weld spots (2a) in the areas shown in the figure, remove car lift brackets (2b) and lower wing retaining bracket (2c).Open the door sill fastenings.3. Use a circular saw to follow the cutting lines shown in the enlargements and in the figure.Use a chisel and hammer to remove spots ground previously.4. Remove the door sill from the car. 1. Straighten the door sill compartment flaps using a mallet and profiled stake.Use a grinding wheel to remove the weld spot residues.Use a rotary brush to clean the treated areas.Apply the electric weld paint finish. Refitting ( Removing ) 1. Fit the part in its seat after thoroughly degreasing and secure using self-locking clips.2. Refit front door (2a), rear door (2b) and front wing (2c).3. Position lower wing bracket (3a) and mark its exact position (3b). Check alignment and gaps around the edges, then remove the parts positioned previously. 1. Use a circular saw to cut part (1a) by laying it in place with front pillar (1b), central pillar (1c) and door sill end section (1d).Trim the cut edges and remove the part. 1. Use a rotary brush to remove the corrosion-proofing from around the inner and outer edge of the door sill (1a), car lift brackets (1b) and lower bracket (1c).2. Make equidistant holes as shown in the figure.Apply electrogalvanised paint to the edges in contact with the car. 1. Position the front car lift bracket at the distance shown in the figure.2. Use a spot welder to weld the areas shown in the figure.3. Position the rear car lift bracket at the distance shown in the figure.4. Use a spot welder to weld the areas shown in the figure.5. Fit the lower wing retaining bracket in the positioned marked previously.6. Use a spot welder to weld the areas shown in the figure. Position the part on the car and secure using self-locking clips.1. Use a spot welder to weld the points indicated.2. Use a MIG welder to seam weld the pillars.3. Use a MIG welder to fill the holes made previously. Correct any deformations in the panel using a profiled stake and mallet.Crimp the reference tabs.1. Use a grinding wheel to level the weld and remove.Use a rotary brush to clean the newly-welded areas. Apply rust-proofing to newly-welded areas.1. Seal the joint lines between the part and the car.Apply paint.2. Apply wax oil inside the door sill.