1056B15 THROTTLE BODY INTERGRAL WITH MDS - R R - Alfa - 166 - eLearn

3314117 - 1056B15 throttle body intergral with mds - r r

) Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 1016A40 ignition coil cover on cylinder head- r+r . - 1048A48 throttle heater sleeve - r r . 1. Disconnect the electrical connection from the butterfly casing integrated with the M.D.S.

	Name	Connector
1	Integrated throttle body actuator	N75

2. Disconnect the electrical connections (2a) and (2b) from the injection/ignition control unit and the earth lead (2c) from the butterfly casing integrated with the M.D.S.

	Name	Connector
2a	Data not available yet	-

	Name	Connector
2b	Data not available yet	-

	Name	Connector
2c	Data not available yet	-

3. Disconnect the accelerator cable from the butterfly casing integrated with the M.D.S.4. Disconnect the injection/ignition wiring from the mounting bracket.5. Undo the bolts (5a) and remove the butterfly casing integrated with the M.D.S. (5b) complete with the injection/ignition control unit (5c).

Refitting ( Removing

)

When refitting, the learning procedure for the butterfly casing integrated with the M.D.S. must be repeated (Carry out Op. 1056B81 run electronic ignition/injection control unit (single) self-learning procedure .

Fit the butterfly casing integrated with the M.D.S. complete with injection/ignition control unit and fix it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BUTTERFLY VALVE CASE/S (MPI)	M6	Air chamber side 0.8 - 1.1

Fix the injection/ignition wiring to the mounting bracket. Connect the accelerator cable to the butterfly casing integrated with the M.D.S. and adjust it (refer to op. 1068A30 accelerator control cable - r + r ). Connect the earth lead to the butterfly casing integrated with the M.D.S.Connect the electrical connections to the injection/ignition control unit.Connect the electrical connection to the butterfly casing integrated with the M.D.S. - 1048A48 throttle heater sleeve - r r . - 1016A40 ignition coil cover on cylinder head- r+r . Connect the negative (-) battery terminal.