3314132 - 1068A30 accelerator control cable - r + r
Removing ( Refitting ) 1. Disconnect the end of the accelerator cable (1a) from the accelerator pedal (1b).
1. Disconnect the end of the accelerator cable (1a) from the butterfly
casing integrated with the M.D.S. and remove the complete cable
(1b) from the engine compartment bulkhead.
Refitting
(
Removing
)
Connect the end of the accelerator cable
to the butterfly casing integrated with the M.D.S. and fit the fairlead
in the special opening in the engine compartment bulkhead.
Ensure that the route of the accelerator cable does not involve sharp bends or interference with moving parts. |
Check that the end travel stop on the throttle
body is in contact when the pedal is fully depressed (throttle open).If not, adjust the accelerator pedal travel stop.