3314463 - 1820B15 hose from rigid intermediate pipe to master cylinder (pump) - r r with pedal unit removed for right hand drive versions
Removing ( Refitting ) Drain the brake-clutch fluid from the reservoir using a suitable syringe.Remove the driver side carpet.1. Undo bolts (1a), remove plastic pin (1b) and remove the under-facia lining driver side (1c).
Undo the nut and open the fuse
access flap. 1. Undo bolt (1a) retaining cable link (1b), then remove the fuse
access flap (1c).
1. Undo bolt (1a) and remove the integrated multiservice control
unit (1b) after disconnecting electrical connections (1c).
For precise identification of the electrical connections, see Wiring Diagrams Section. |
1. Cut the band retaining the master cylinder cover and remove after
releasing the pipe and electric wiring from the same bands.2. Disconnect and remove the hose from rigid supply pipe to clutch
pump.
Refitting
(
Removing
)
Place the hose from rigid supply
pipe to clutch pump back in its housing and connect it. Fit the master cylinder cover back in its
seating and secure it with the bands.Connect the electrical connection and the
pipe to the bands on the cover. Refit the junction unit in its seating
and secure with its bolt.Connect the electrical connections to the
integrated multiservices unit, then refit it in its seating and
secure with its bolt.Place the fuse access cover back in its
housing then secure the rod with the bolt.Close the fuse access flap and secure with
the nut.Place the driver side under-facia wiring
back in its seat then secure with the bolts and plastic pin.Put the driver side floor carpet back in
place. - 1820B08 Clutch release HYDRAULIC SYSTEM - Bleeding air and
restoring level