3314571 - 3330B02 pedal assembly - r r

Removing ( Refitting ) Place the steering wheel in the centred position with the wheels straight. Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op.   5530B10  battery - r+r ).

	Name	Connector
-	Battery	A1B

 - 7040A43  cover (one only) for wiring beneath facia - r r .  - 7040A37  fuse box cover - r r .  - 7040A65  passenger compartment box lock , one , r r . 1. Remove the rubber protector (1a) and the accelerator pedal travel stop (1b). 1. Move aside the floor carpet, unscrew the nuts (1a) and remove the steering column universal joint guard (1b).2. Undo the bolt fixing the steering column to the power steering box pinion.

The bolt is pretreated and cannot therefore be refitted.

1. Withdraw and remove the lower steering shaft.  - 5580C18  air bag module - r+r .

Closely observe the safety regulations established for this operation.

 - 7040A26  steering column trim - r+r .  - 4110A11  steering wheel - r+r for replacement or check for versions with air bag .  - 5550A12  complete stalk unit - r+r for versions with air bag . 1. Remove the clutch pedal switch (1a) and brake pedal switch (1b) from their seats. - 5505A18  multi-function control unit - r r . 2. Undo the bolt (2a) and move the junction unit (2b).  - 7040D12  engine front side cover (one) lh or rh - r r (left)  - 7040D14  engine bay rear side cover (one) lh or rh - r r (left) 1. Undo the bolt (1a) and move aside the coolant reservoir (1b) without disconnecting its pipes. Drain the brake-clutch fluid from the reservoir using a suitable syringe.1. Remove the master cylinder guard.2. Disconnect the hose from the clutch reservoir to the master cylinder on the master cylinder side.3. Disconnect the rigid delivery pipe from the master cylinder. 1. Remove the split pin (1a), withdraw the pin (1b) and disconnect the brake pedal (1c) from the servo unit rod.Disconnect the throttle cable from the pedal. 1. Undo the bolt (1a) and nuts (1b) and remove the complete pedal assembly (1c) after disengaging it from the servo unit. Refitting ( Removing ) 1. Fit the complete pedal assembly (1a), connect it to the servo unit and tighten the nuts (1b) and bolt (1c) to the specified torque.

	Fastening	Component	Ø	Value(daNm)
1b	Nut	PEDALS	M8	Brake servo side 1.4 - 1.6

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	PEDALS	M8	Bodyshell side 1.3 - 1.5

Connect the accelerator cable to the pedal.Connect the brake pedal to the servo unit rod and secure with the pin and split pin.