5010A12 ENGINE/HEATER LINE - R R - Alfa - 166 - eLearn

3314722 - 5010A12 engine/heater line - r r

) Position the vehicle on the ramp. Make sure that the ignition is OFF (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

1. Undo the drain plug in the radiator and drain the engine coolant.

Collect the coolant in a suitable container.

- 7040D12 engine front side cover (one) lh or rh - r r (left and right). - 7040D14 engine bay rear side cover (one) lh or rh - r r (left and right). - 5050B34 windscreen wiper arm/s complete with blade - r+r . - 7055A18 Windscreen base TRIM - R.R. . - 5050B38 windscreen wiper assembly - r+r or repair . 1. Disconnect the water supply pipe to the heater, heater side.

- 1048A28 vacuum air circuit resonator pipe - r+r . 1. Disconnect the water supply pipe to the heater from the thermostat.

1. Remove the water supply pipe to the heater.

Refitting ( Removing

) Place the water supply pipe to the heater back in its housing. Connect the water supply pipe to the heater to the thermostat. - 1048A28 vacuum air circuit resonator pipe - r+r . Supply the engine cooling system with the recommended fluid.

	Type	Component	Name	Qty.
-	Fluid [l]	ENGINE COOLING CIRCUIT	Alfa Romeo Climafluid Super Permanent -40	7.9