3315159 - 7030B70 sun-roof control switch - r+r

Removing ( Refitting )  - 7040H32  sliding roof switch door panel - r rMove the sun-roof to spoiler position by hand or by operating the electrical control.1. Disconnect the motor electrical connection.

	Name	Connector
1	Data not available yet	N35

2. Unscrew the sun-roof motor retaining bolts.3. Take the motor out through the hole in the roof panel.If necessary, disconnect the electrical leads from the control unit block. Refitting ( Removing ) Check that the motor is undamaged.If necessary, check the connections between control unit, motor and switch.Connect the electrical wires to the control unit base, if disconnected previously.Check the motor is working properly.1. Before refitting the motor, connect to electrical connection (1a) and turn cam (1b) until its TDC is aligned with microswitch (1c). Turn cam anticlockwise so that it passes point C first. Fit the motor in its seat.Tighten the bolts.Connect the electrical connection.Check the sun-roof is working properly. - 7040H32  sliding roof switch door panel - r r