3315367 - 1084B18 engine oil pump, removed - check at bench (Automatic transmission)

Removing ( Refitting ) 1. Undo the cap (1a) and remove the oil pressure relief valve (1b).2. Undo the bolts (2a) and remove the oil pump cover (2b).3. Remove the drive gear.4. Remove the driven gear.Remove the crankshaft front oil seal.
Refitting ( Removing ) Check that the radial clearance between pump casing and driven gear is within the recommended limits; if this is not the case, replace the complete oil pump.

MeasurementValue
-Radial clearance between pump casing and driven gear ()0.080 - 0.186
Check that the clearance between the oil pump cover support plane and the upper side of the gears is within the recommended limits; if this is not the case, replace the complete oil pump.

MeasurementValue
-Clearance between pump cover contact surface and top side of gears ()0.025 - 0.070
Check that the height of the spring for the engine oil pressure relief valve is within the recommended limits; if this is not the case, replace the spring.

MeasurementValue
-Height (mm)36
at test load (daN)6.4 - 7.2
1. Fit a new crankshaft front oil seal (1a) using the tool (1b).

NameCountry
1bFitting tool1.821.247.000
Fit the driven gear. Fit the drive gear.Fit the oil pump cover and tighten the bolts.
Manually rotate the gears to check that they turn without sticking.
Fit the oil pressure relief valve and tighten the cap.