3315539 - E2012 MAIN BEAM HEADLAMPS - Functional description (Right hand drive)
Functional description
The main beams are controlled by electronic
Check device
M45
, which receives control signals from the
switches and controls the bulbs while also checking the various
lines.
The supply for the Check device
M45
arrives directly from the battery (maxifuse CENTR of
B5
)
at pins 1 and 6 of connector C, via fuse
F11
of junction
unit
B1
.
The supply controlled by the ignition (INT/A)
arrives via fuse
F1
of junction unit
B1
at pin 9
of connector C: pin 7 of connector C is earhed.
The circuit for the main beam headlamps
is operated by the steering column switch unit
H5
, placing
the switch in the main beam headlamps position or closing the 'flasher' contact.
In the first case, the supply arrives from the dipped headlamps
control
H6
, (
See E2011 DIPPED HEADLAMPS
).
In the second case, on the other hand, the supply arrives directly
from the line controlled by the ignition (INT/A) at pin 4, via fuse
F1
of junction unit
B1
.
When the lights are on, the steering column
switch unit
H5
controls the supply of the main beam headlamps
from pin 3 of connector A. This signal energizes the relay
R4
,
located in the relay control unit B3, which supplies the headlamps
F10
(left) and
F11
(right). Each circuit is protected by a fuse
in relay control unit
B3
:
F2
for the left hand headlamp and
F1
for the right hand headlamp.
The left hand headlamp supply line also
lights up the 'main beams on' warning light inside instrument panel
E50
- pin 6 of connector C - while pin 16 of connector A acts as an
earth.