3314224 - 1020D50 crank shaft rear mount - apply silicone to mating surfaces with crank case sump and flywheel removed (Automatic transmission)

Removing ( Refitting ) 1. Undo the nuts (1a) and remove the rear main bearing cap (1b) using the tools (1c) and (1d).

NameCountry
1cLever1.821.006.001

NameCountry
1dExtractor1.821.006.002
Remove the half-bearing.Remove the crankshaft rear oil seal.
Refitting ( Removing ) Thoroughly remove the sealant residues from the rear bearing cap seat, the small holes and the contact surfaces with the oil sump.Thoroughly remove all traces of engine oil using heptane or a similar solvent.Fit the rear bearing cap complete with bearing half-shell and secure it, tightening the nuts to the specified torque using the specific tool for angle tightening.

FasteningComponentØValue(daNm)
-NutMAIN BEARING CAPSM12(Engine crankcase side) 2.4 ÷ 2.6 + 77? ÷ 81?

NameCountry
-Protractor1.860.942.000
1. Fit the crankshaft rear oil seal (1a) using the tool (1b).
The oil seal should be fitted in its housing so that it covers the small openings (1c).

NameCountry
1bFitting tool1.821.150.000
1. Apply the specified sealant (1a) through the holes (1b) and check that it emerges from the whole length of the contact area (1c) between the cap and the engine block and from the holes (1d).

TypeComponentNameQty.
1aSealantENGINE REAR MOUNT GASKETSLOCTITE 5900-
The oil sump should be fitted within 15 minutes of applying the sealant in the openings for the crankshaft rear support.