1056B17 THROTTLE BODY INTERGRAL WITH DVL - R R (AUTOMATIC TRANSMISSION) - Alfa - 166 - eLearn

3314252 - 1056B17 throttle body intergral with dvl - r r (Automatic transmission)

) Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 7040D12 engine front side cover (one) lh or rh - r r (left). - 7040D14 engine bay rear side cover (one) lh or rh - r r (left). - 1048B44 heat exchanger/manifold pipe - r r . 1. Disconnect the electrical connection from the butterfly casing integrated with the D.V.L.

	Name	Connector
1	Integrated throttle body actuator	N75

2. Undo the bolts (2a) and remove the throttle body integrated with the D.V.L. (2b) complete with gasket.

Refitting ( Removing

)

When refitting, it is essential to repeat the learning procedure for the throttle body integrated with D.V.L. (Carry out Op. 1056B81 run electronic ignition/injection control unit (single) self-learning procedure .

Fit the throttle body integrated with the D.V.L. complete with gasket and fix it with the relevant bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	BUTTERFLY VALVE CASE/S (MPI)	M6	Air chamber side 0.8 - 1.1

Connect the electrical connection to the butterfly casing integrated with the D.V.L. - 1048B44 heat exchanger/manifold pipe - r r . - 7040D14 engine bay rear side cover (one) lh or rh - r r (left). - 7040D12 engine front side cover (one) lh or rh - r r (left). Connect the negative (-) battery terminal.