2710A10 DRIVE SHAFT WITH JOINTS (ONE), L/H OR R/H - R + R - Alfa - 166 - eLearn

3314533 - 2710A10 drive shaft with joints (one), l/h or r/h - r + r

) Position the vehicle on the ramp. - 4450B10 Front WHEEL (one) - R.R. . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r . - 7055B54 under-engine guard - r r . 1. Relieve the staking and undo the nut securing the drive shaft to the vertical link.2. Undo the drive shaft bolts.

The above bolts are treated with eslok anti-slackening material and must therefore be replaced whenever they are removed.

3. Remove the safety plates.

- 4410A80 damper lower fork - r r . Lift the vertical link using a hydraulic jack and attach it temporarily to the upper wishbone.1. Rotate the brake disc to the left and withdraw the drive shaft complete with couplings.

Refitting ( Removing

) Refit the drive shaft complete with couplings in its seating.Release the vertical link from the upper wishbone and lower it on the hydraulic jack. - 4410A80 damper lower fork - r r . 1. Fit the safety plates (1a) and tighten the drive shaft bolts (1b) to the specified torque.

The above bolts have been treated with an eslok type material therefore they should be replaced each time they are removed.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT DRIVE SHAFT COMPLETE WITH JOINTS	M8	(Differential intermediate drive shaft side 4/0 .) 4.4÷.