5520B12 STARTER MOTOR - R+R FOR VERSIONS WITH A/C - Alfa - 166 - eLearn

3314852 - 5520B12 starter motor - r+r for versions with a/c

) Position the vehicle on the lift. Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 7055B54 under-engine guard - r r . - 1076B70 exhaust pipe between pre-catalytic converter and catalytic converter - r r . - 1064A44 left hand or right hand sleeve (one) joining left hand or right hand cylinder head to turbocharger - r+r (right) - 1072C34 r/h exhaust manifold - r + r and replace seal . 1. Undo the nuts (1a) and disconnect the electrical connections (1b) from the stater motor.

	Name	Connector
1b	Starter motor	A20

2. Release the electrical wiring from the band on the starter motor.

1. Undo the bolts (1a) and remove the starter motor (1b), complete with bracket (1c).2. Remove the spacer.

Refitting ( Removing

) Fit the starter motor, complete with spacer and bracket, and fix it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STARTER MOTOR	M8	Gearbox side 1.8 - 2.2

Fix the electrical wiring to the band on the starter motor.Connect the electrical connections to the starter motor and fix them using the nuts. - 1072C34 r/h exhaust manifold - r + r and replace seal . - 1064A44 left hand or right hand sleeve (one) joining left hand or right hand cylinder head to turbocharger - r+r (right) - 1076B70 exhaust pipe between pre-catalytic converter and catalytic converter - r r . - 7055B54 under-engine guard - r r . Connect the negative (-) battery terminal.