3315262 - 7045J54 reduction mechanism for lifting front part of cushion and sliding front seat, lh or rh, - r r following electrical check

Removing ( Refitting ) - 7045A10 l/h or r/h front seat (one) - r+r 1. Cut connection collar (1a) and disconnect lift and slide motor electrical connections (1b).2. Unscrew fastenings securing the drive gear unit to the guide and the guide to the seat frame.3. Take off the retaining ring on the vertical slide pin.4. Remove guide/plate assembly (4a) together with motor/drive gear unit (4b) by withdrawing idler shaft (4c) from control shaft (4d). Place the motor/drive gear unit on a work bench.1. Use a rubber mallet to remove the pinion from the control unit.2. Unscrew bolts (2a) and remove motors (2b) from the drive gear unit. Refitting ( Removing ) Check the motors and drive gear are in good condition.Fit the motor and tighten the retaining bolts.Fit the idler shaft.Position the control/motor assembly, then fit the plate/guide assembly and drive home using the rubber mallet.Tighten the fastenings securing the drive gear unit to the guide and the guide to the seat frame.Fit a seeger to the vertical slide pin.Fit a new collar and connect the motor supply connectors.Check the unit is working properly using an appropriate electrical supply system.- 7045A10 l/h or r/h front seat (one) - r+r