3310A30 FRONT BRAKE CALIPER (ONE) - R.R. - Alfa - 166 - eLearn

3314547 - 3310A30 FRONT BRAKE CALIPER (one) - R.R.

) Position the vehicle on the ramp Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 4450B10 Front WHEEL (one) - R.R. . - 3330E10 FLEXIBLE PIPE (one), left or right, to front brake calipers - R.R . . 1. Remove the clip securing the brake caliper to the bracket.2. Disconnect the electrical connection on the brake pad wear warning light cable.

	Name	Connector
2	Left brake pad wear sensor (switch)	K20

	Name	Connector
2	Right brake pad wear sensor (switch)	K21

3. Undo the bolts (3a) and remove the front brake caliper (3b) complete with brake pads.

Refitting ( Removing

) Fit the brake caliper complete with brake pads and tighten the bolts to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT BRAKE CALIPER ASSEMBLY	M14	15.2 - 16.8

Connect the electrical connection on the brake pad wear warning light cable.Fit the clip securing the brake caliper to the bracket. - 3330E10 FLEXIBLE PIPE (one), left or right, to front brake calipers - R.R . . - 3330A10 BRAKE FLUID - Check level and top up, if necessary. . - 3330A14 HYDRAULIC BRAKING SYSTEM - Bleed air . - 4450B10 Front WHEEL (one) - R.R. . Connect the negative (-) battery terminalRemove the car from the ramps.