1040B30 FUEL DELIVERY LINE - R R (AUTOMATIC TRANSMISSION) - Alfa - 166 - eLearn

3314103 - 1040B30 fuel delivery line - r r (Automatic transmission)

) Position the vehicle on the lift. Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

Discharge the fuel supply pressure (see Group 10 Warnings). - 7040B10 load platform (luggage platform) trim - r+r . 1. Undo the bolts (1a) and remove the access cover (1b) for the immersed pump assembly complete with gauge.2. Disconnect the rapid attachment for the fuel supply pipe from the immersed pump assembly complete with gauge.

Release the fuel supply pipe from the fixing bands. 1. Disconnect the fuel supply pipe from the fuel manifold.

1. Release the fuel supply pipe from the fixings under the body.

1. Undo the nut securing the handbrake cable mounting bracket.2. Undo the bolts (2a) and nut (2b) and remove the heat shield (2c).

1. Position a hydraulic jack under the rear suspension crossmember.2. Undo the bolts (2a) and lower the rear suspension crossmember (2b), as necessary, using the hydraulic jack.

1. Position a hydraulic jack under the fuel tank.2. Undo the bolts (2a) and lower the fuel tank (2b), as much as necessary.

Release the fuel supply pipe from the remaining fixings near the fuel tank.Place the fuel tank in its housing and fix it temporarily.Remove the hydraulic jack from under the tank.Remove the fuel supply pipe from the engine compartment.

Refitting ( Removing

) Working in the engine compartment, place the fuel supply pipe back in its housing.Position a hydraulic jack under the tank.Undo the bolts and lower the fuel tank, as necessary.Fix the fuel supply pipe to the fixings near the fuel tank.Refit the fuel tank in its seating and secure with its bolts.Remove the hydraulic jack from under the tank.1. Replace the rear suspension crossmember (1a) in its housing using the hydraulic jack (1b) and fix it tightening the bolts (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Bolt	REAR CROSS-BEAM	M10	Bodyshell side 4.7 - 5.1

Fit the protective heat shield and fix it using the bolts and nut.Tighten the nut securing the handbrake cable mounting bracket.Fix the fuel supply pipe to the underbody fixings.Connect the rapid attachment for the fuel supply pipe to the fuel manifold.Fix the fuel supply pipe to the fixing bands.Connect the fuel delivery pipe to the immersed pump assembly complete with gauge.Fit the access cover to the immersed pump assembly complete with gauge and fix it using the bolts. - 7040B10 load platform (luggage platform) trim - r+r . Connect the negative (-) battery terminal.Remove the vehicle from the ramp.