3315328 - 7210A15 R.R. HEADLAMP HOUSING/FRONT WING CROSSMEMBER

Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary before carrying out the following procedure.
1. Unscrew bolt (1a) securing the upper radiator attachment and bolt (1b) retaining the intercooler sleeve bracket.2. Unscrew retaining bolts (2a) shown in the figure, then remove headlamp housing connection beam (2b).
Refitting ( Removing ) 1. Provisionally position part (1a) on the car and screw in retaining bolts (1b) without tightening.2. Fit the bonnet lid catch in its seat.
1. Lower the bonnet lid. Check it is properly aligned and that the gap around the edge is even.Remove the catch and headlamp housing connection beam from the car.
Paint the headlamp housing beam in accordance with the specified cycle.