3315329 - 7210A16 R.R. WING LOWER CROSSMEMBER

Removing ( Refitting )  - 7210A15  R.R. HEADLAMP HOUSING/FRONT WING CROSSMEMBERMove all fouling parts.Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary.
1. Use a pneumatic saw to cut along the lines shown in the figure.2. Remove the section of the side panel connection beam cut previously.
Use a rotary brush to clean the areas to be ground in order to expose the weld spots.1. Drill out the weld spots exposed previously.2. Use a scalpel and mallet to remove the side panel connection beam cut edges.
Straighten the panel edges using a mallet and profiled stake.Use a grinding wheel to remove the weld spot residues.1. Apply the electric weld paint finish.
Use a rotary brush to remove the corrosion-proofing from around the inner and outer edge of the part.1. Apply electric weld paint finish to the eges in contact with the car.
Refitting ( Removing ) 1. Fit the part correctly using self-locking clips.2. Use a spot welder to weld the areas shown in the figure.
1. Fit the part correctly using self-locking clips.2. Use a spot welder to weld the areas shown in the figure.
1. Use a grinding wheel to level weld residues and remove.Use a rotary brush to clean the newly-welded areas.Check that the welded parts are correctly positioned.
1. Spread rust-proofing inside the beam.Apply paint.Apply wax.
 - 7210A15  R.R. HEADLAMP HOUSING/FRONT WING CROSSMEMBER