3315332 - 7210A50 front wing upper insert
Removing ( Refitting ) Check if any of the connected parts are deformed by checking body alignment dimensions. Use appropriate measurement tools (reference rigs, templates or gauges).Straighten the body if necessary.
1. Use a chamfering machine to crop the weld spots shown in the
figure.2. Drill out the weld spots shown in the figure.3. Remove the upper insert from the car.
Straighten the upper wing insert
seat flaps using a mallet and profiled stake.Use a grinding wheel to remove the weld
spot residues.Use a rotary brush to clean the treated
areas.1. Apply the electric weld paint finish to the areas shown in the
figure.
Refitting
(
Removing
)
1. Lay the part in its seat and secure using self-locking clips.2. Refit upper wing (2a) and bonnet lid (2b).Check alignment and ensure the surrounding
gap is even.Remove the front wing and the bonnet lid.
1. Drill out equidistant holes on the part as shown in the figure.Use a grinding wheel to remove the corrosion-proofing
from around the inner and outer edge of the parts.2. Apply electric weld paint finish to the mating edges.
1. Position the upper wing insert in it seat and secure using self-locking
clips.2. Use a spot welder to weld the areas indicated.3. Use a MIG welder to fill the holes made previously.
1. Correct any deformations in the panel using a profiled stake
and mallet.Use a grinding wheel to remove and level
residues.Use a rotary brush to clean the newly-welded
areas.Check that the welded parts are correctly
positioned.
Apply rust-proofing to newly
welded areas.1. Use sealant to seal joint lines between parts and the car.Apply paint.2. Apply new foam in the area shown in the figure.