1008A43 POWER UNIT RIGID MOUNT - AUTOMATIC TRANSMISSION SIDE - R R (AUTOMATIC TRANSMISSION) - Alfa - 166 - eLearn

3314292 - 1008A43 power unit rigid mount - automatic transmission side - r r (Automatic transmission)

) Place the vehicle on a ramp. Make sure that the ignition is OFF (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

- 4450B10 Front WHEEL (one) - R.R. (left).. - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 7055B54 under-engine guard - r r . 1. Undo the bolt (1a) and disconnect the earth lead (1b) from the gearbox side rigid power unit support.

	Name	Connector
1b	Battery earth	C1

Position a hydraulic jack under the gearbox.1. Undo the bolts fixing the gearbox side support flexible mounting to the rear suspension frame.Raise the power unit, as necessary, using the hydraulic jack.2. Undo the bolts fixing the gearbox side rigid power unit support to the manual gearbox.3. Remove the gearbox side rigid power unit support (3a) complete with flexible mounting (3b).

1. At the bench, undo the nut (1a) and separate the gearbox side rigid power unit support (1b) from the flexible mounting (1c).

Refitting ( Removing

) 1. Fix the flexible mounting (1a) to the gearbox side rigid power unit support (1b) tightening the nut (1c) to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
1c	Nut	POWER UNIT GEAR BOX END RIGID MOUNT	M10	(Flexible mounting side) 3.8 - 4.7

1. Fit the gearbox side rigid power unit support (1a) complete with flexible mounting (1b).2. Tighten the bolts securing the gearbox side rigid power unit support to the gearbox.

	Fastening	Component	Ø	Value(daNm)
2	Bolt	POWER UNIT GEAR BOX END RIGID MOUNT	M10	(Automatic transmission side) 4.3 - 5.3

Lower the power unit, as necessary, using the hydraulic jack.3. Tighten the bolts fixing the gearbox side support flexible mounting to the rear suspension frame to the specified torque.

	Fastening	Component	Ø	Value(daNm)
3	Bolt	GEARBOX SIDE RUBBER MOUNT	M8	(Front suspension frame side) 2.4 - 2.9

Remove the hydraulic jack from under the gearbox.Connect the earth lead to the gearbox side rigid power unit support and fix it using the bolt. - 7055B54 under-engine guard - r r . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 4450B10 Front WHEEL (one) - R.R. (left).. Connect the battery terminal (-).Remove the car from the ramp.