2130B40 GEAR SELECTION SOLENOID UNIT - R R (AUTOMATIC TRANSMISSION) - Alfa - 166 - eLearn

3314509 - 2130B40 gear selection solenoid unit - r r (Automatic transmission)

) Place the vehicle on a ramp. Make sure that the ignition is in the OFF position, then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1

- 7055B54 under-engine guard - r r . - 1048A28 vacuum air circuit resonator pipe - r+r . - 2130B38 automatic transmission top cover - r + r on vehicle . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . - 2135B72 electronic automatic transmission input rpm sensor - r r . 1. Disconnect the electrical connection.

	Name	Connector
1	Data not available yet	-

2. Remove the electrical connection retaining clip.

1. Undo the bolts and move the gear selection solenoids unit aside as necessary.2. Undo the bolt (2a) and withdraw the electronic automatic transmission output rpm sensor (2b) from its seating.3. Remove the gear selection solenoids unit (3a) complete with electrical wiring (3b) and electronic automatic transmission output rpm sensor.

Refitting ( Removing

) Offer up to its seating the gear selection solenoids unit complete with electrical wiring and electronic automatic transmission output rpm sensor.Refit in its seating the electronic automatic gearbox output rpm sensor and tighten the bolt to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	ELECTRONIC AUTO TRANSMISSION OUTPUT RPM SENSOR	-	-

Refit in its seating the gear selection solenoids unit and tighten the bolts to the specified torque.

Check that the electrical wiring is in the correct position.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	SOLENOID UNIT	-	-

Fit the electrical connection retaining clip.Connect the electrical wiring. - 2135B72 electronic automatic transmission input rpm sensor - r r . - 1048A34 sleeve(s) from flow meter to air supply capacity case - r + r . - 7055B39 front additional wheel arch half (one), lh or rh, front element - r r (left). - 2130B38 automatic transmission top cover - r + r on vehicle . - 1048A28 vacuum air circuit resonator pipe - r+r . - 7055B54 under-engine guard - r r . Connect the negative (-) battery terminal.Remove the vehicle from the ramp.